How to move the drill holes into the right trace?

1, open the gerber files. Files-Import–AutoImport, choose the file, check Scan each Gerber & English, click Next.
2, click any layer to see and remember the format Digits, then change the NC Data format Digits same to the previous data. Click-OK-Finish.
3, setting the Unit from English to Metric.
4, choose Edit-Move, knock the”W”, knock the left mouse button to selecte the needed area, then click the left mouse button again to comfirm the area.
5, knock the right mouse button,choose anyone as the center point, move the drill layer to the right trace place.
So finish all the steps.

You may also like

• 

  What is the “aspect ratio”?
• 

  hs code electronic,What is the HS code for circuit boards?
• 

  What is Metal Core Printed Circuit Board and Its Advantages?
• 

  What is a Zero PCB Board? – Best Technology
• 

  Dry Soldering: How to Prevent and Fix Dry Solder Joint?
• 

  Design and Application of PVD in DPC Manufacturing Process
• 

  How to Clean Flux Off PCB? – Best Technology
• 

  What are thick and thin film ceramic circuit boards used for?

This entry was posted on 星期五, 12 8 月, 2016 at 11:12 上午 and is filed under FAQ. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.